The effects of the addition of 1,7-dipyrrolidinyl-substituted perylene diimide (1,7-PyPDI) to a traditional poly(3-hexylthiophene) (P3HT):[ 6,6]-phenyl C61-butyric acid methylester (PCBM) bulk-heterojunction blend on the performance of organic solar cells, are described. When the 1,7-PyPDI amount in the mixture is accurately tuned, the power conversion efficiency (.) of the 1,7-PyPDI-doped cells is enhanced compared to a reference non-doped device. Cells fabricated by spin-coating blends from chloroform solution with P3HT (monomer): PCBM:1,7-PyPDI molar ratio of 6.85:1:0.03 resulted in 39.6% higher power conversion efficiency than P3HT: PCBM blend. The efficiency improvement is attributed to possible photochemical interactions between the three components of the blend, which contribute to enhance the charge separation, and minimize the charge recombination processes. Moreover, the increased absorption and the microstructural implications induced by the introduction of 1,7-PyPDI contribute to explain the enhancement of the solar cell performance. (C) 2013 Elsevier B. V. All rights reserved.