Chemical Engineering and Processing, Vol.88, 10-18, 2015
Gas-liquid distribution in tubular reactors with solid foam packings
The axial evolution of gas-liquid distribution patterns in co-current downward gas-liquid two-phase flow through solid foam packings of different pore density expressed by pores per inch was experimentally studied. The experimental results are based on time-averaged capacitance measurements of the liquid phase with embedded wire-mesh sensors, positioned at different axial heights of the solid foam packing. The measurements revealed the spatial distribution of the liquid phase saturation, which was applied to quantify the degree of liquid maldistribution. Both the spray nozzle and the multipoint distributor provide rather uniform initial liquid distributions across the foam packings with low maldistribution factors at superficial liquid velocities above 0.009 mis. However, the uniform initial irrigation deteriorates along the foam packing length, in particular for foams with low pore density. The gas flow rate does not significantly influence the liquid distribution. Furthermore, the foam's ability to radially spread the liquid phase in the cross-section downstream from a single drip point distributor was studied and found to be low, independent from the pore density. (C) 2014 Elsevier B.V. All rights reserved.
Keywords:Solid foam;Packed bed reactor;Liquid saturation;Maldistribution;Pre-wetting mode;Liquid spreading