Iron oxide and copper chromite are the known burn rate enhancers used in a composite solid propellant. Lot of research has been carried out to understand the mechanism or location of action of the burn rate modifiers so as to better tailor the burning rate of a composite propellant. The literature is still very confusing in affirming the mechanism. Here, a systematic study has been carried out, by undertaking experiments at varying levels of combinations of the individual components (ammonium perchlorate, which is oxidizer and hydroxyl terminated poly butadiene, which is both fuel and binder) of composite solid propellant. Firstly, thermal gravimetric analysis, differential scanning calorimetry and burning rate measurements on the individual components are carried out to study the effect of iron oxide and copper chromite on the components themselves. It has been noticed that though both iron oxide and copper chromite are effective on ammonium perchlorate, iron oxide is slightly more effective than copper chromite. Also, copper chromite enhanced the binder melt flow, while iron oxide reduced it. These are followed-up by experiments on sandwich propellants, which give greater insight and enables better understanding of the behavior of iron oxide and copper chromite in composite propellants, as these are simple two-dimensional analogue of the composite solid propellants. Finally, experiments are carried out on the composite solid propellants to obtain a holistic understanding of the behavior/location of action of iron oxide and copper chromite in them. These studies are used to explain certain unexplained but observed phenomena, at the same time elucidating the location of action of these burn rate modifiers in composite solid propellant combustion. Based on these observations, it has been proposed that both iron oxide and copper chromite are primarily acting on the condensed phase. These studies are further complimented with experiments to analyze the thermal conductivity measurements of various propellant samples. This is pursued to understand the reason for the differences in burn rate pressure index for the composite propellants with iron oxide and with copper chromite. It has been understood from these studies that the thermal conductivity of a composite propellant is a key parameter, which affects the burn rate pressure index. Literature has never addressed it from this perspective. (C) 2014 The Combustion Institute. Published by Elsevier Inc. All rights reserved.