TiBN/CrN multilayered superlattice coatings with modulation periods Lambda (bilayer thickness) ranging from 22.5 to 4.2 nm and modulation ratio R (the thickness ratio of CrN and TiBN layers) ranging from 6:1 to 3:1 were synthesized using an industrial-scale cathodic arc ion plating system in an Ar-N-2 gas mixture. X-ray diffraction (XRD), transmission electron microscopy (TEM) and nanoindention were employed to investigate the influence of modulation period and ratio on microstructure and mechanical properties of the multilayers. The sharp interfaces and nanoscale multilayered modulation were confirmed by TEM. TiBN/CrN multilayer coatings were crystallized with orientations at the (1 1 1), (2 0 0) and (2 2 0) crystallographic planes and the microstructure was strengthened at (2 0 0) preferred orientation. The maximum hardness of 38.6 GPa and elastic modulus of 477 GPa were obtained at Lambda = 11.7 nm and R = 5:1. The lowest value of the friction coefficient at 0.32 sliding against a WC-Co ball was obtained at a bilayer period of 11.7 nm, compared to those of the coatings with other modulation periods and monolithic coatings. The wear rate of the multilayered coatings was also lower than those of the monolithic CrN and TiBN coatings. (C) 2015 Elsevier B.V. All rights reserved.