In cutting of stainless steel with coated tool, the steel chip adhering to tool surface is usually severe and consequently causes serious adhesive and frictional problems, which is the major reason for the failure of coated tool. To solve the problem, a surface engineering approach, namely, a highly functionalization of tool surfaces by textures may be of great importance. Thus, the effect of micro/nano-scale textures on anti-adhesive wear properties of TiAlN coated tools in AISI 316 austenitic stainless steel cutting was investigated. For this purpose, two types of surface textures were fabricated on the rake faces of WC/Co carbide tools: (i) micro-scale textures fabricated by Nd:YAG laser, (ii) micro/nano-scales textures fabricated by Nd:YAG laser and femtosecond laser. Then, these textured tools were deposited with TiAlN coatings using cathode arc-evaporation technique. Wet cutting experiments were carried out with the micro-scale textured coated tool (MCT), micro/nano-scale textured coated tool (MNCT), and the conventional coated tool (CCT). Results obtained in this work demonstrated the feasibility of fabricating micro- or micro/nano-scale textures on tools substrate surfaces to improve the anti-adhesive wear properties of TiAlN coated tool. The rake face micro/nano-scale textured tool was the most effective. Moreover, mechanisms for the anti-adhesive properties enhancement were proposed. (c) 2015 Elsevier B.V. All rights reserved.