Experimental data over the temperature range from (263 to 365)K are presented on the 0.1 MPa density and air-liquid interfacial tension for four ionic liquids with tricyanomethanide anion and pyridinium, pyrrolidinium- and imidazolium-based cations, still poorly or even not studied in these respects at all. The reported density data were obtained using a single-sinker buoyancy method with an estimated combined expanded uncertainty at 0.95 confidence level U-c = 1.0 kg m(-3) (7 x 10(-4)Q). The surface tension data were obtained by the Wilhelmy plate method with U-c = 0.08 mN m(-1) and by du Nouy ring method with U-c=0.3 mN m(-1). The Kruss K100Mk2 tensiometer was used to determine the buoyancy and surface tension forces. An empirical model is reported generating recommended values for 0.1 MPa density of 21 ionic liquids with imidazolium-, pyridinium- and pyrrolidinium-based cation and with four different cyano-functionalized anions. The worst-case error of the generated recommended densities is estimated to 0.1%. The model predicts densities for additional 33 members of the same homologous series, for which there exist no experimental density data. A similar model based on the parachor with estimated worst-case error of 0.6 mN m(-1) (1%) is reported for the surface tension of the same set of ionic liquids. The scope of the surface tension model and reliability of the generated surface tension values are limited due to too small database of available surface tension data. (C) 2015 Elsevier B.V. All rights reserved.