Coincident three-component particle velocity measurements are performed in an almost 9 m high cylindrical riser (internal diameter 0.10 m) of a pilot-scale cold-flow Circulating Fluidized Bed set-up, using two Laser Doppler Anemometry (LDA) probes. Experiments are performed with superficial gas velocities of 3.5 m/s and 5.3 m/s near the solids inlet line and with an average solids volume fraction of 0.0002. The particle flow is observed to be highly disturbed due to the asymmetrical position of both the gas and the Y-shaped solids inlet line. A jet-like particle flow and a by-passing streaming gas jet around the particles are formed. Just below the solids inlet line a downward oriented particle velocity is measured. Particles are immediately lifted by the ascending gas and spread over the entire cross-sectional tube area. Near the solids inlet line the axial and radial particle velocity fluctuations are of the same order of magnitude as the corresponding mean particle velocity components, showing that the flow is anisotropic. The radial particle velocity fluctuations decrease fast as the radial inflow of particles is transformed into axial particles flow. The turbulence intensity in the inlet section of the dilute riser flow is found to be extremely high, indicating that the flow is far from being fully developed. The total particle shear stress profiles near the solids inlet line indicate a high momentum transfer from radial to axial particle transport. The particle fluctuation energy values calculated based on experimental data are nearly double than the values corresponding in fully developed flow studied previously. (C) 2015 Elsevier Ltd. All rights reserved.