The present work analyzes the thermal performance of a cylindrical copper mesh wick heat pipe using water based CuO nanofluids. The studies are extended further by varying the heat pipe inclination angle and heat input. Thermophysical properties of CuO/DI water nanofluids are also effectively analyzed. The reduction in thermal resistance ratio is about 23.83% and 10.43% respectively for 1.0 and 1.5 wt.% of CuO nanofluid compared with low concentration. Evaporation and condensation heat transfer coefficient ratios are improved by the use of CuO nanofluid and the maximum enhancement obtained is 30.50% and 23.54% respectively for an optimum tilt angle of 60 degrees. Thermal efficiency of heat pipe tends to increase with the heat load and inclination angle and an improvement of 33.34% is observed for 120W heat load at 60 degrees inclination angle compared with the horizontal heat pipe. After the experimentation, characterizations of mesh wick structures are carried out. It is found that the deposition of CuO nanoparticles creates a thin coating layer on the wick surfaces in evaporator section. This increases the surface wettability and enhances the thermal performance of heat pipe. (C) 2015 Elsevier Ltd. All rights reserved.