A butt-joint was formed between two pipes of dissimilar materials, steel and aluminum, by winding a wetted roving of carbon fiber with epoxy at +/- 45 degrees angle. On the curing of the epoxy, a tight carbon fiber reinforced polymer (CFRP) sleeve was formed, joining the ends of the pipes. The CFRP butt-joint was characterized for two kinds of loads: tensile and bending. Based on the joint strength performance, the specimens were categorized into two groups, thin and thick CFRP sleeved specimens. In the tensile testing, the thin sleeved specimen failed through the breakage of the CFRP sleeve at the joint plane because the axial stress developed in CFRP sleeve exceeded the ultimate strength of the CFRP. However, the thick sleeved specimens resisted the axial load in the sleeve and the weaker adherend, the aluminum pipe, slipped out of the CFRP sleeve. In the flexural testing, the thin CFRP sleeved specimens also failed by failure of the CFRP sleeve at the joint plane while the specimens of thick CFRP sleeve failed by the formation of a plastic hinge near the edge of the CFRP sleeve.