Comminution tests aim to measure the comminution properties of ore samples to be used in designing and sizing the grinding circuit and to study the variation within an ore body. In the geometallurgy context this information is essential for creating a proper resource model for production planning and management and process control of the resource's exploitation before and during production. Standard grindability tests require at least 10 kg of ore sample, which is quite a lot at early project stages. This paper deals with the development of a method for mapping the variability of comminution properties with very small sample amounts. The method uses a lab-scale jaw crusher, standard laboratory sieves and a small laboratory tumbling mill equipped with a gross energy measurement device. The method was evaluated against rock mechanics tests and standard Bond grindability test. Within this approach textural information from drill cores is used as a sample classification criterion. Experimental results show that a sample of approximate 220 g already provides relevant information about the grindability behavior of iron ores at 19% mill fillings and 91% fraction of the critical mill speed. The gross energy measured is then used to calculate an equivalent grinding energy. This equivalent energy is further used for predicting the variations in throughput for a given deposit and process. Liberation properties of the ore connected to grindability elaborates energy required for grinding and significances of it when deciding to move to higher grinding energy considering the improvement of liberation of the desired mineral. However, high energy significantly enhanced the degree of liberation of magnetite and is expected to improve the concentrate grade after downstream treatment. The higher the magnetite content the better is the liberability of magnetite and the lower the energy required to liberate the desired mineral. Liberability of magnetite is also affected by texture classes containing low magnetite content. A methodology that combines this information has been developed as a practical framework of geometallurgical modeling and simulation in order to manage technical and economic exploitation of resource at early, project stages and during mining operations. (C) 2014 Elsevier Ltd. All rights reserved.