The spent liquor, SL, of neutral sulphite semi chemical pulping process contains lignosulfonate and hemi-celluloses, but it is currently treated in the wastewater treatment of the process. This treatment decomposes the lignosulfonate. However, lignosulfonate can be extracted for a better use, but the extraction process is not an easy task. The main objective of this work was to extract lignosulfonate from SL via treating the SL with surfactant. The results showed that the acidification of SL to pH 1.8 caused 6% lignosulfonate, 53% hemicelluloses, and 7% COD removals from SL Acidification followed by dodecyltrimethylammonium chloride, DTAC, treatment of SL at the optimal conditions of 22 degrees C, 1.8 pH and 10 mg/g of DTAC/SL yielded 40% lignosulfonate, 78% hemicelluloses, and 25% COD removals. Model solutions were prepared via dissolving commercial lignosulfonate and xylan in solutions or purifying SL via membrane dialysis in order to investigate the impact of SL components, i.e. hemicelluloses and residual cooking chemicals, on the isolation of lignosulfonate from SL. The model analyses confirmed that the presence of impurities, i.e. residual cooking salts, significantly affected the isolation of lignosulfonate from the SL, but the presence of hemicellulose had a minor effect in extracting lignosulfonate from SL via DTAC treatment. In addition, the elemental analysis confirmed that DTAC and lignosulfonate had a ratio of 0.584 mol/mol in precipitates. (C) 2015 Elsevier B.V. All rights reserved.