PDMS has been widely utilized for microfluidic chips and microchannel detections, as its good optical properties are the prerequisite to achieve accurate and efficient detection. However, it is difficult to obtain effective information for opaque liquids. With the development of microchannel detection for wider fields, it is imperative to obtain more comprehensive information of the observed objects by integrating high transmission with enhanced reflection. This article investigates reflection enhancement by Polydimethylsiloxane (PDMS) film with inverted conical microholes array. PDMS film with inverted conical microholes array is fabricated by replication from the silicon mold with inverted microcones array which is prepared by Inductively Coupled Plasma (ICP) etch tool. The monolayer PDMS film with inverted conical microholes array shows a two-fold effectively increase in reflection, approximately up to 15%, at a broad wavelength range of 637-1131 nm and 1214-1350 nm, compared with bare PDMS film. In addition, the reflection can be further enhanced by multilayered lamination of PDMS film with inverted conical microholes array, and the enhancement is also dependent on the lamination way, i.e., for bilayer laminations, the maximum reflection enhancement occurs when with face-to-back lamination, and 32.79% larger than that with back-to-face lamination. From the experiments, the maximum reflectivity of 8-layered PDMS films can obtain 64.4% while the maximum reflectivity of monolayer PDMS film barely has 17.5%. The transparent film with inverted conical microholes array for reflection enhancement may find a variety of applications in optical devices, microchips, and energy conservation technologies etc. (C) 2016 Elsevier B.V. All rights reserved.