A Cu-10.3/SiO2 catalyst was prepared for the conversion of benzyl alcohol to benzonitrile through amination-dehydrogenation process. The catalyst showed high activity in the reaction, and a yield as high as 98.0% was reached under the optimized conditions. The catalyst was characterized by XRD, TEM-EDX, TG-DSC, N-2 adsorption-desorption and IR of absorbed pyridine methods. The characterization results disclosed that the doping of copper created Lewis acid sites in the matrix of SiO2. The doped copper in the fresh catalyst was present in CuO state, which was reduced to elemental Cu by H-2 generated in situ in the catalytic run. The characterization results also disclosed that the catalyst deactivation was mainly caused by the carbonaceous deposition on the surface of the catalyst in the catalytic reaction. The experimental results confirmed that most activity of the catalyst can be recovered.at 550 degrees C online by blowing air into the reactor. Partial sintering of copper particles took place during the catalytic run, which led to the slight decreases of Lewis acidity and dehydrogenation capacity, therefore, caused deviation of the performance of the regenerated Cu-10.3/SiO2 catalyst from that of the fresh one. (C) 2016 Elsevier B.V. All rights reserved.