In this study, P-LGMgO (low-grade MgO and NaH2PO4 center dot 2H(2)O), P-CaO (CaO and NaH2PO4 center dot 2H(2)O), and P-MgCa (low-grade MgO, CaO and NaH2PO4 center dot 2H(2)O) were used for the solidification/stabilization (S/S) of electrolytic manganese residue (EMR). Relevant characteristics such as ammonia nitrogen and manganese stabilization behavior, unconfined compressive strength (UCS), probable S/S mechanisms, and EMR leaching test were investigated. The results demonstrate that using P-LGMgO had higher stabilization efficiency than P-CaO and P-MgCa for the S/S of EMR at the same stabilization agent dose. The stabilization efficiency of ammonia nitrogen and manganese in the EMR were 84.0% and 99.9%, respectively, and the UCS of EMR was 5.1 MPa using P-LGMgO process after curing for 28 days when the molar ratio of Mg:P was 5:1 and dose of stabilization agent was 12 wt%. In this process, ammonia nitrogen was stabilized by struvite (NH4MgPO4 center dot 6H(2)O), and manganese by bermanite (Mn-3(PO4)(2)(OH)(2)center dot 4H(2)O) and pyrochroite (Mn(OH)(2)). The leaching test results show that the values of all the measured metals on the 28th day were within the permitted level for the GB8978-1996 test suggested by China's environmental protection law and the concentration of ammonia nitrogen can be reduced from 504.0 mg L-1 to 76.6 mg L-1. (C) 2016 Elsevier B.V. All rights reserved.