The application of spray coated silver nanowires (AgNWs) onto OPVs for building Integrated Photovoltaics (BIPVs) is demonstrated. By using AgNWs with PEDOT:PSS, a transparent conductive layer was demonstrated on top of an P3HT:PCBM active layer with a sheet resistance of 30 Omega/square for 90% transparency. This has been applied to two separate configurations; semi-transparent OPVs for solar glazing applications and OPVs onto an opaque substrate, namely steel. For the latter, a novel technique to planarise the steel substrate with an intermediate layer is also presented, with a substantial decrease in surface roughness reported to ensure that the substrate is smooth enough to use for OPV fabrication. The use of SU-8 as an intermediate layer reduced the surface roughness to R-A=10 nm, which is one of the lowest values reported to date, and was achieved on a low cost substrate (DC01 low carbon steel) using solution processing. (C) 2016 Elsevier B.V. All rights reserved.