Thermal conductivity of eicosane-based phase change materials was enhanced by suspending highly conductive silver nanoparticles. Three batches of solid eicosane-silver samples with mass fractions (0, 1, 2, 3.5, 5, 6.5, 8 and 10 wt%) of nanoparticles were obtained under three different solidification routes: ice-water bath, room temperature and oven solidification. The transient plane source technique was used to measure the thermal conductivity at different temperatures starting at 10 degrees C and ending close to the melting point of each sample. Results showed an increase in the value of thermal conductivity as the temperature increased, and when close to melting point, a sharp rise in thermal conductivity was observed. Also, the slowly-prepared oven solidification route samples exhibited the highest thermal conductivity values while the ice-water samples that were prepared quickly showed the least increase. For samples with an additive loading greater than 2 wt%, a non-monotonic relationship was obtained between the thermal conductivity and the weight fraction of Ag nanoparticles, regardless of the method of solidification. In addition to thermal conductivity measurement, the latent heat of fusion of the samples was investigated, utilizing differential scanning calorimetry. Results exhibited a decrease in the latent heat and the melting point of the samples as the additives loading increased due to the decrease in the number of molecules of eicosane in the samples. (C) 2016 Elsevier Ltd. All rights reserved.