In this work, we study the mechanical properties of sodium dodecyl sulfate (SDS) and dodecylamine hydrochloride (DAFT) micellar films at a graphite surface via atomic force microscopy (AFM). Breakthrough forces for these films were measured using silicon nitride cantilevers and were found to be 1.1 0.1 nN for a 10 mM DAH film and 3.0 0.3 nN for a 10 mM SDS film. For 10 mM SDS films, it was found that the addition of 1.5 mM of NaCl, Na2SO4, or MgCl2 produced a 50-70% increase in the measured breakthrough force. Similar results were found for 10 mM DAFT films when NaCl and MgCl2 were added. A model was developed on the basis of previous work on lipid films and CMC data gathered via spectrofluorometry measurements to predict the change in normalized breakthrough forces with added salt concentrations for SDS and DAFT films. Using this model, it was found that the activation volume required to initiate the breakthrough was roughly 0.4 nm(3) for SDS and 0.3 nm(3) for DAH, roughly the volume of a single molecule. Normalized breakthrough force data for SDS films with added MgCl2 showed an unexpected dip at low added salt concentrations. The model was adapted to account for changing activation volumes, and a curve of activation volume versus magnesium concentration was obtained, showing a minimum volume of 0.21 nm(3). The addition of 0.2 mM SDS to a 10 mM DAFT solution was found to double the measured breakthrough force of the film. Images taken of the surface showed a phase change from cylindrical hemimicelles to a planar film that may have produced the observed differences. The pH of the bulk solution was varied for both 10 mM SDS and DAFT films and was found to have little effect on the breakthrough force.