Although Poly(lactic acid) (PLA) possesses many desirable properties, above all biodegradability, its heat deflection temperature is too low for many desirable applications. Similarly, to any other polymers, also for PLA the physical and mechanical properties in the solid state depend on the morphology and crystallinity degree, which in their turn are determined by the thermomechanical history experienced during solidification. A large crystallinity degree is highly desirable to increase the heat resistance of PLA but is rather difficult to reach during injection molding due to the very slow crystallization kinetics of this material. In this work, the crystallization kinetics of an injection molded PLA grade was assessed in function of the thermal history by using calorimetric analysis. The cold crystallization kinetics (starting from the amorphous glassy sample) turned out to be faster than melt crystallization kinetics. Following the indications gained from crystallization kinetics, some samples were injection molded imposing different thermal histories. The effect of molding conditions on crystallinity was determined. This finding was adopted to develop a postmolding stage which allows obtaining crystalline samples in times much shorter (of a factor about two) with respect to samples injection molded in a hot mold kept at temperatures close to the maximum crystallization rate. (C) 2016 Society of Plastics Engineers