Waste chloride pickle liquors from hot-dip galvanizing plants, steel plants and flue dust contain reasonable amounts of heavy metals such as Zn, Cr, Ni, etc. Iron is invariably associated with most of these materials and comes into solution during leaching. Thus, the synergistic extraction of zinc(II) and iron(III) from leach solutions in tri-n-butyl phosphate (TBP)-di(2-ethylhexyl) phosphoric acid (D2EHPA) system diluted in kerosene was investigated. The Zn and Fe concentrations in the leach liquor used in the present study were 2 g/L. Experiments were carried out in the pH range of 0.5-4.0, temperature of 25 degrees C, using sole D2EHPA, sole TBP and D2EHPA-TBP mixtures at different ratios. Results showed that the co-extraction of zinc(II) and iron(III) increased with increasing equilibrium pH using D2EHPA. It is demonstrated that the mixtures of TBP and D2EHPA are more efficient and selective than D2EHPA alone. At low pH values, the separation factor is low when pure D2EHPA is used as an extractant; however, using TBP as a synergist, the separation factor increases and results in a better separation of zinc from iron. Increasing TBP to D2EHPA ratios in the organic phase caused a slight shift to the right in the extraction isotherm of iron and a marked shift to the right in the extraction isotherm of zinc, and the maximum separation factor of 13.3 x 10(3) was achieved at a TBP to D2EHPA volume ratio of 4:1 (0.58 M TBP: 0.12 M D2EHPA). Furthermore, the effect of equilibrium pH, organic to aqueous phase ratio and Cl- concentration on the selective extraction was investigated. Using two extraction stages at the O/A ratio of 2:1 and pH(e) (equilibrium pH) of 3 and 1 for zinc and iron, respectively, 99% of zinc(II) and 96.25% of iron(III) were extracted.