Incorporating reduced graphene oxide (rGO) or Fe3+ ions in TiO2 photocatalyst could enhance photocatalytic degradation of organic contaminants in aqueous solutions. This study characterized the photocatalytic activities of TiO2-Fe and TiO2-rGO nanocomposites immobilized on optical fibers synthesized by polymer assisted hydrothermal deposition method. The photocatalysts presented a mixture phase of anatase and rutile in the TiO2-rGO and TiO2-Fe nanocomposites. Doping Fe into TiO2 particles (2.40 eV) could reduce more band gap energy than incorporating rGO (2.85 eV), thereby enhancing utilization efficiency of visible light. Incorporating Fe and rGO in TiO2 decreased significantly the intensity of TiO2 photoluminescence signals and enhanced the separation rate of photo-induced charge carriers. Photocatalytic performance of the synthesized nanocomposites was measured by the degradation of three pharmaceuticals under UV and visible light irradiation, including carbamazepine, ibuprofen, and sulfamethoxazole. TiO2-rGO exhibited higher photocatalytic activity for the degradation of pharmaceuticals under UV irradiation, while TiO2-Fe demonstrated more suitable for visible light oxidation. The results suggested that the enhanced photocatalytic performance of TiO2-rGO could be attributed to reduced recombination rate of photoexcited electrons-hole pairs, but for TiO2-Fe nanocomposite, narrower band gap would contribute to increased photocatalytic activity. (C) 2017 Elsevier B.V. All rights reserved.