Metal Hydrides (MH) can absorb large quantities of hydrogen at room temperature and ordinary pressure. Because MH can store hydrogen at a pressure less than 0.1 MPa safely and compactly, it is looked to as a method of storing hydrogen produced by electricity derived from renewable energy sources. To study this method of storing renewable energy, we made a MH tank system which could store hydrogen in the range of 1000 Nm(3). A Mm-Ni-Mn-Co alloy was used for this MH tank system. MH becomes pulverized with absorbing and desorbing hydrogen, and this causes the problem of MH tank transformation owing to the partial distribution of the pulverized MH powders. Our MH material, named "Hydrage (TM)," was made using a technique to compose the MH powders with polymer materials without decreasing the hydrogen absorption and desorption rate. With this technique, the MH powders were immobilized, and strain on the MH tank was reduced. Furthermore, this technique enabled uniform dispersion of the MH powders, and high-density filling in MH tank was achieved relative to that attainable in a conventional MH tank. An MH tank system with a capacity of 1000 Nm(3) is 1,800 mm in width, 3,150 mm in length, and 2,145 mm in height. The system for renewable energy storage consists of 9 tanks. About 7.2 tons of MH were used in this system. This system could work at temperatures from 25 to 35 degrees C, and its maximum hydrogen absorption and desorption rate is 70 Nm(3)/h with a medium flow rate of 30 NL/min. This type of MH tank system, which can store a large amount of hydrogen safely and compactly, has the potential to become popular with various applications in the future. (C) 2017 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.