Potentiostatic electrodeposition of Cadmium Telluride (CdTe) films from the alkaline ionic liquid (IL), butyl methyl imidazolium chloride (BmimCl) at 80 degrees C has been carried out at an applied potential of -1.45 V vs. platinum (Pt) wire. The influence of the substrate and electrolytic IL bath content on the morphology and composition of electrodeposited CdTe thin films has been presented. The sheet resistivity of the modified FTO substrate increases to similar to 17.7 Omega/sq. While treatment of the substrate prior deposition changes the individual CdTe morphology, the composition as well as the film compactness has been found to vary with the treatment of the IL based electrolytic bath. SEM micrograph shows inter-connected needle-like and herring bone morphology of electrodeposited CdTe along with agglomerated lumps of Te and flecks of Cd. Interdependency of surface morphology and elemental composition of electrodeposited CdTe films were observed by SEM & EDX analysis. It has been shown that hydroxylated Fro surface facilitates three dimensional (3D) nucleation and growth in the presence of O-2 in the electrolytic bath. 3D nucleation and growth mechanism leads to Cd-rich CdTe films. Electrodeposition that does not proceed through 3D nucleation and growth shows only Te-rich layer. Also, the net charge transfer was found more in Cd-rich CdTe layers as compared with Te-rich CdTe deposits.