A Radioactive Particle Tracking (RPT) technique was used to study the effects of the internal baffles in the stripping section of the Fluid Coker (TM), called sheds, have on the behavior of wet agglomerates that are formed when residual oil is injected into the Coker. Vapor emitted by reacting wet agglomerates below the sheds rises and causes shed fouling. The release of vapor from agglomerates can be estimated by combining the RPT results with a coking reaction model. The study found that the sheds reduce the time agglomerates spend in the shed zone, which in turn reduces the amount of organic vapor that reaches the sheds, but at the same time increase the wetness of the agglomerates that exit to the recirculation line, which results in the loss of valuable liquid. The research also found that the best type of shed, from the point of view of agglomerate motion, is the mesh-shed. Finally, experimental data indicate that reducing the cross sectional area of the sheds from 50% to 30% increases the time that the agglomerates spend above the shed zone, and thus reduces the flow of vapor emitted below the sheds. (C) 2018 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan. All rights reserved.