An improved technique for casting highly oriented films of block copolymers from solutions subjected to flow is presented. Polymer solutions were rolled between two counter-rotating adjacent cylinders while at the same time the solvent was allowed to evaporate. As the solvent evaporated, the block copolymers microphase separated into globally oriented structures. Using this method known as ’roll-casting’ we present in this paper a study of the morphology of polystyrene-polybutadiene-polystyrene (PS/PB/PS) triblock copolymer cast with and without additional high molecular weight homopolymers. The pure copolymer films consisted of polystyrene cylinders assembled on a hexagonal lattice in a polybutadiene matrix in a near single-crystal structure. Blends of copolymer with high molecular weight polystyrene and/or polybutadiene, phase separated into ellipsoidal regions of homopolymer embedded in an oriented block copolymer matrix. Annealing the films resulted in conversion of the homopolymer regions to spheres accompanied by some misalignment of the copolymer microdomains. The morphology of these films as revealed by TEM is discussed. A brief discussion of the flow field that develops in the experimental system is also presented and its similarity to the flow field of our previous work is shown.