The versatile use of submicron-sized particles (0.1-1 mu m) requires new manufacturing methods. One possibility for the preparation of submicron-sized particles is spray drying. However, the generation of small droplets at a high production rate and the precipitation of submicron particles are quite challenging. In order to produce a sufficient amount of fine and uniform droplets, a two-fluid nozzle with internal mixing was combined with a cyclone droplet separator. The precipitation of particles was realized with an electrostatic precipitator. Considering the difficulty of electrostatic precipitation concerning explosion risks and to make it capable using organic solvents, the spray dryer was integrated in a pressure resistant vessel. Based on previous experiments, the now presented design is compact and the electrostatic precipitator is shortened. In addition, enhanced drying conditions ensured a controlled and reproducible preparation of submicron-sized particles. Thus, high separation efficiencies were shown. Spray-drying experiments were conducted with the model substance mannitol. With the cyclone droplet separator, a fine and uniform spray with a droplet size smaller 2 mu m was produced. This robust atomizing technique is capable for high concentrations. For a 10 wt% mannitol solution, particles in the submicron range d(50,3) = 0.7 mu m were produced. (C) 2018 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan. All rights reserved.