In this study, a method has been proposed to obtain the failure envelope of brittle adhesives using the experimental failure loads of precracked single lap joints (SLJs). The proposed technique is based on the principles of linear elastic fracture mechanics (LEFM), on J-integral relations, and on results of a numerical analysis. Compared to the previous approaches, the introduced experimental method has some advantages such as low manufacturing costs and simpler test procedure. The proposed method can also provide a wide range of mode mix ratios without the need of an additional apparatus. The fracture envelope obtained from the proposed method was then verified by performing some fracture tests including double cantilever beam (DCB), end-notched flexure (ENF), and single leg bending (SLB) specimens. Good correlation was seen between the fracture envelopes of the proposed method and the ones obtained from the fracture mechanics experiments.