Wetting test and classical molecular dynamics (MD) simulations were employed to investigate the adherent behaviors of hydroxyl-terminated polybutadiene (HTPB), a typical high viscosity liquid widely used as a binder in rocket motor propellants, onto the copper (Cu) surfaces with different topographies. Experimental data show that the microstructures protruding above the substrate surfaces can be 'sensed' by the HTPB droplet, which has been indicated by the smaller contact angles and higher interface tension for this specific liquid on the rough surfaces (featured with sinusoidal structures or square pillars) than that on the smooth surface. Simulation results reveal the atomic details of spreading process of HTPB chains, with diverse diffusion propensities presented on different surfaces. The HTPB droplet spreads widely on the smooth surface, exhibiting a roughly isotropic trend. On the contrary, the state of this high viscosity liquid on the sinusoidal-structured surface is featured by wide contact diffusion along the run of groove, but relatively restricted extension in the direction perpendicular to the groove, as a result of the barriers exerted by the nearest neighbouring peaks. The existence of nanoscale pillars increases the exterior surface area of Cu substrate, therefore the HTPB chains can penetrate deep to envelop the peripheries of the pillars, forming abundant direct contacts with Cu surface and producing a highest HTPB-Cu interaction energy, which well accords with the experimental results about the adherent strength of HTPB. (C) 2018 Elsevier B.V. All rights reserved.