Due to the heterogeneity of the pore structure, there is still much residual fossil hydrogen energy in the pore space. In this study, the distribution of residual fossil hydrogen energy after imbibition with liquid nanofluid (LNF) has been studied through the. Firstly, relevant properties of the LNF were tested, including particle size, wettability alteration, and interfacial tension (IFT). Then, one micromodel under both oil-wet and water-wet conditions was used to elucidate the difference of residual oil after imbibition. Moreover, the difference of imbibition processes with oil-wet and water-wet models was further studied. Finally, the influence of dimensions and coordination numbers of pores was investigated. Besides, the impact of fluid type on imbibition efficiency was also compared through microfluidic experiments. Results show that the residual oil saturation is significantly higher in the oil-wet micromodel than in the water-wet micromodel, even the wettability alteration additive was used. There are four kinds of locations for residual oil after imbibition in water-wet micromodel, while only three kinds of locations for residual oil in oil-wet micromodel. The imbibition rate and residual oil saturation in small pores are higher than the larger ones. Due to the unbalanced force at pore throats, a micromodel with a high coordination number has lower residual oil saturation. Besides, the lower residual oil saturation is obtained by adding the LNF. This paper provides a micro-visual method to understand the imbibition process under different wettability and pore structures in fossil hydrogen reservoirs. (C) 2020 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.