Hypothesis: Recently, switchable or stimuli-responsive emulsions have attracted much research interest in many industrial fields. In this work, a novel CO2/N-2-responsive surfactant was designed and developed to facilitate the formation of switchable oil-in-water (O/W) emulsions with fast switching characteristics between a stable emulsion and separate phases upon alternatively bubbling CO2 and N-2. Experiments: The novel CO2/N-2-responsive surfactant was facilely prepared by mixing an anionic fatty acid (oleic acid) and a cationic amine (1,3-Bis (aminopropyl) tetramethyldisiloxane) at a 1:1 molecular ratio, which was assembled based on electrostatic interactions. The structure and properties of the novel CO2/N-2-responsive switchable surfactant were investigated by Fourier-transform infrared spectroscopy (FTIR), proton nuclear magnetic resonance (H-1 NMR) spectroscopy, and interfacial tensions. Findings: The developed surfactant shows an excellent interfacial activity at the oil/water interface, which can significantly reduce the dosage of the switchable surfactant compared with previous CO2/N-2-responsive surfactants. The dynamic interfacial tension of n-decane and aqueous phase decreased from 45 mN m 1 to 5 mN m 1 within 100 s with the addition of 0.2 mM surfactant. In this work, a low concentration of the novel switchable surfactant (e.g., 20.0 mM) can realize reversible emulsification and demulsification in an emulsion system as compared with the high dosage (e.g., similar to 150 mM) in previous reports, which will bring huge economic benefits in industrial applications in the future. Moreover, this work expands the family of ion-pair surfactants to small amino-functionalized molecules beyond Jeffamine D-230, which promotes the development of simple and switchable ion-pair surfactant. It is found that the O/W emulsions stabilized by the switchable surfactant show excellent stability, which can be stored for over 60 days at room temperature without any obvious change. Interestingly, the stable O/W emulsion is completely demulsified upon bubbling CO2 for 30 s and can be easily re-emulsified to the initial state after purging N-2 at 60 degrees C within 10 min, which demonstrates a rapid and highly efficient switching behavior. The reversible emulsification and demulsification process is ascribed to the reversible assembly and disassembly of the switchable surfactant, which is induced by the removal and purge of CO2. (C) 2020 Elsevier Inc. All rights reserved.