An x-ray flux delivery system consisting of a compact storage ring and dedicated beamlines is now in routine use in the IBM Advanced Lithography Facility in East Fishkill, New York. The beamlines have been designed for use with a stepper that scans the mask and wafer vertically through a stationary beam. The performance of the system from a lithographic standpoint is reported. The measured size and stability of the synchrotron x-ray source will be presented, and the design and performance of the beamlines will be discussed. The beamlines have been designed to provide high intensity, uniform illumination over a wide field. The overall performance of the system has been evaluated by measuring the flux at the mask plane in the stepper. A horizontal uniformity of better than +/- 2% over a field more than 50 mm wide has been achieved; the vertical uniformity is limited by the uniformity of the stepper scanning mechanism. The delivered mask-incident flux per milliampere of stored beam current has been found to be 1.5 mW/(mA cm), approximately four times greater than obtained with a simple planar mirror. A 100 mJ/cm2 resist with a mask transmission of 50% therefore requires a less than 2 s exposure (plus overscan overhead) for a 2.5 cm high field at a typical stored current of 200 mA, independent of the field width (up to the maximum of more than 50 mm). In addition, the source has proved itself to be highly reliable, with beam available for 99% of the scheduled time over the most recent seven month period.