Injection-moulded plates of four polypropylene-based copolymers with ethylene or an unconjugated diene as the comonomer were subjected to oxygen plasma treatments. The main objective was to investigate how the degree of wettability and the adhesion properties were influenced by the type and amount of comonomer and by selected plasma parameters. The change in wettability was monitored by static water contact angle measurements and the adhesion between plasma-treated polypropylene plates and a two-component polyurethane lacquer was evaluated by a 90 degrees peel test. No significant difference in the degree of wettability depending on material composition or treatment conditions could be observed. However, the lacquer adhesion was shown to be a function of both material composition and discharge power, while the influence of gas pressure was less clear. For all processing conditions crard, the lacquer adhesion was distinctly improved as the diene content was increased. An increasing extent of crosslinking reactions combined with a reduction in the number of main chain scissions are proposed to account for the observed results.