The successful use of palladium ion implantation into polyimide to seed an electroless plated film of copper on the polyimide surface is reported. Polyimide (Hitachi PIX 3400) was implanted with palladium ions to doses of 1.5 x 10(15)-1.2 x 10(17) ions cm(-2) using a MEVVA ion implanter. The implanted ions acted as sites for nucleation of copper film. A copper film was then deposited on implanted polyimide using a commercial electroless plating solution. The ion energy was kept low enough to facilitate a low critical ’seed’ threshold dose that was measured to be 3.6 x 10(16) Pd ions cm(-2). Test patterns were made using polyimide to study the adaptability of this technique to form thick structures. Plated films were studied with optical microscopy, Rutherford Backscattering Spectrometry (RES) and Profilometry. The adhesion of films was qualitatively assessed by a ’scotch tape test’. The film growth (thickness) was observed to be linear with plating time. A higher implantation dose led to greater plating rates. The adhesion was found to improve with increasing dose.