Simulation studies have predicted that maximum lipase activity is reached with fed-batch operation strategies. In this work, two different fed-batch operational strategies have been studied : constant substrate feeding rate and specific growth rate control. A constant substrate feeding rate strategy showed that maximum aqueous lipolytic activity (55 U/mL) was reached at low substrate feeding rates, whereas lipase tends to accumulate inside the cell at higher rates of substrate addition. In the second fed-batch strategy studied, a feed back control strategy has been developed based on the estimation of state variables (X and mu) from the measurement of indirect variables such as CER by means of mass spectrometry techniques. An on-off controller was then used to maintain the specific growth rate at the desired value by adjusting the substrate feeding rate. A constant specific growth rate strategy gave higher final levels of aqueous lipolytic activity (117 U/mL) at low specific growth rates. At higher specific growth rates the enzyme remained accumulated inside the cell, as was observed with a constant feeding fed-batch strategy. With a constant specific growth rate strategy, lipase production by Candida rugosa was enhanced 10-fold compared to a batch operation. Purification studies have demonstrated that lipolytic and esterasic specific activity ratios of Candida rugosa isoenzymes can be modified by using different operational conditions. These studies have also showed that the isoenzymes obtained in a controlled growth rate strategy are around three- to four-fold more active than those obtained in a constant feeding rate strategy.