This article compares the cure behavior and properties of phthalonitrile polymers derived from three different monomers, namely, 4,4'-bis(3,4-dicyanophenoxy)biphenyl, 2,2-bis [4-(3,4-dicyanophenoxy)phenyl] hexafluoropropane and 2,2-bis [4(3,4-dicyanophenoxy)phenyl] propane. Rheometric measurements with monomer melt in the presence of an aromatic diamine curing agent reveal that the rate of the cure reaction differs for the three monomers. The rate is dependent on the concentration of the curing agent. The glass transition temperature advances with increasing extent of cure and disappears upon postcure at temperatures in excess of 350 degrees C. Based on thermogravimetric analysis, the thermal stability of all three polymers are comparable, whereas the fluorine-containing resin shows the best oxidative stability at elevated temperatures. Microscale calorimetric studies on all three polymers reveal that the char yields are high and the total heat release upon exposure to 50 kW/m(2) flux for each polymer is low, compared to other thermosets. Flexural strength ranges between 80-120 MPa. The water uptake under ambient conditions is less than 3% by weight after submersion in water for seven months.