Heavy-oil-in-water (o/w) emulsions containing produced sand were prepared using commercially available emulsifiers. The emulsions were tested in beakers for emulsion type, quality, and sand-retention characteristics. The apparent viscosities of the o/w emulsions were measured. The effects of polymer addition on the apparent viscosity and sand-carrying capability of the emulsions were also studied. The results of the breaker tests indicate that most emulsifier solutions water-wet the beaker wall and temporarily improve heavy-oil flow characteristics. However, most of the chemicals also water-wet the sand particles and cause sand dropout. The Flothin F2 chemical alone showed stable oil dispersion and, in combination with the Flocon 4800C polymer, showed very good sand-retention, viscosity-reduction, and stable oil-dispersion characteristics.