Poly(ethylene terephtalate) (PET) crystallization was shown by atomic force microscopy (AFM) to occur at 85 degreesC in the first few nanometers near the polymer-air interface. The surface was fully transformed into spherulites after 30 min, while no signs of bulk crystallization were observed by FTIR. All the observed spherulites presented a nucleation centre, indicating that the crystallization process started at the surface of the film. Tapping mode AFM confirmed that the spherulites were not covered by an amorphous layer. The most probable explanation is a decrease of T-g near the surface. Due to the poor crystallization conditions, the constitutive units of the spherulites were;mail crystalline blocks. By changing the annealing time, it was possible to produce PET surfaces with different surface fractions consisting of semi-crystalline material (spherulites) and amorphous matrix. This provided a controlled surface heterogeneity on the submicrometer scale, with a contrast in terms of stiffness, roughness and swelling by organic solvents.