In the oil sands industry, undesirable water-in-oil emulsions are often formed during the bitumen recovery process where water is used to liberate bitumen from sand grains. Nearly all of the water is removed except for a small percentage (similar to1 to 2%), which remains in the solvent-diluted bitumen as micrometer-sized droplets. Knowledge of the colloidal forces that stabilized these water droplets would help to increase our understanding of how these emulsions are stabilized. In this study, the thin liquid film-pressure balance technique has been used to measure isotherms of disjoining pressure in water/toluene-diluted bitumen/water films at five different toluene-bitumen mass ratios. Even though a broad range of mass ratios was studied, only two isotherms are obtained, indicating a possible change in the molecular orientation of surfactant molecules at the bitumen/water interfaces. At low toluene-bitumen mass ratios, the film stability appears to be due to a strong, short-range steric repulsion created by a surfactant bilayer. Similar isotherms were obtained for water/toluene-diluted asphaltene/water films, indicating that the surface active material at the interface probably originated from the asphaltene fraction of the bitumen. However, unlike the bitumen films, films of toluene-diluted asphaltenes often formed very rigid interfaces similar to the "protective skin" described by other researchers.