This paper presents the experimental results carried out in dimpled tubes for laminar and transition flows and completes a previous work of the authors focused on the turbulent region. It was observed that laminar flow heat transfer through horizontal dimpled tubes is produced in mixed convection, where Nusselt number depends on both the natural convection and the entry region. Employing water and ethylene glycol as test fluids, the following flow range was covered: x* = 10(-4)-10(-2) and Ra = 10(6)-10(8). The experimental results of isothermal pressure drop for laminar flow showed dimpled tube friction factors between 10% and 30% higher than the smooth tube ones. Moreover, it was perceived that roughness accelerates transition to critical Reynolds numbers down to 1400. Correlations for the laminar friction factor f = f (Re, h/d) and for the critical Reynolds Re-crit = Re-crit (h/d) are proposed. The hydraulic behaviour of dimpled tubes was found to depend mainly on dimple height. In mixed convection, high temperature differences in the cross section were measured and therefore heat transfer was evaluated by a circumferentially averaged Nusselt number. Experimental correlations for the local and the fully developed Nusselt numbers Nu(x) = Nu(x) (x*, Ra) and Nu(infinity) = Nu(infinity) (Ra) are given. Results showed that at low Rayleigh numbers, heat transfer is similar to the smooth tube one whereas at high Rayleigh, enhancement produced by dimpled tubes can be up to 30%.