Oscillatory reactions over palladium foil and wire catalysts during the oxidation of methane have been investigated over a wide range of reaction temperatures and argon/methane/oxygen feed gas compositions. Characterisation of the catalyst has also been carried out using scanning electron microscopy (SEM) techniques, which revealed the presence of a porous surface. This suggested that the metal surface has undergone a change since the reaction commenced, and using X-ray powder diffraction (XRD) techniques the palladium phase was shown to be the dominant phase present. Hysteresis phenomena were observed in the activity of the reaction as the temperature was cycled up and down, showing that the metal surface was continually changing throughout the reaction. The activation energies of the reaction during the high reactivity mode, PdO, and low reactivity mode, Pd, were also calculated. Oscillation rates were observed to depend on the dominant surface. Oscillations were frequent when the high reactivity mode was dominant while the activation energy of this mode was found to be low. When the low reactivity mode was dominant, the oscillations were slower :and the activation energy was three times larger. The results obtained imply that the behaviour of the palladium surface, switching back and forth from the reduced state to the oxidised state, is responsible for the oscillatory behaviour seen in this system: