There is little detailed work relating the physical process that occurs during milling to the mechanical properties and mechanism of particle breakage. Very often, the selection of an appropriate mill and subsequently the determination of its optimum operating conditions are by trial and error. This paper look into optimizing the operating conditions of a ball mill through statistical analysis and the effect of temperature on the milling behavior of a common pharmaceutical excipient, microcrystalline cellulose (MCC). In addition, the bulk milling behavior of MCC is compared to its single particle breakage behavior. In this work, milling is conducted in a Retsch single ball mill where a bed of powder is subjected to impact by a steel ball in a horizontal cylindrical container. The container is vibrated horizontally at a set frequency, causing the ball to impact on the bed of particles. It is found that the finest MCC product can be achieved by milling a 2 g batch of material using a 12 mm ball size and at a frequency of 18 Hz. Temperature is found to have insignificant effect on the extent of breakage of MCC in both bulk milling and single particle impact testing. Milling and single particle impact experiments have both shown that MCC is more susceptible to breakage with increasing strain rate. In conclusion, the single impact tests could be, used successfully for predicting the bulk milling behavior of the material, as shown in the case of MCC.