The effect of oils, hardness, and calcium soap on foam stability of aqueous solutions of commercial surfactants was investigated. For conditions where negligible calcium soap was formed, stability of foams made with 0.1 wt% solutions of a seven-EO alcohol ethoxylate containing dispersed drops of n-hexadecane, triolein, or mixtures of these oils with small amounts of oleic acid could be understood in terms of entry, spreading, and bridging coefficients, i.e., ESB analysis. However, foams made from solutions containing 0.01 wt% of three-EO alcohol ethoxysulfate sodium salt and the same dispersed oils were frequently more stable than expected based on ESB analysis, reflecting that repulsion due to overlap of electrical double layers in the asymmetric oil-water-air film made oil entry into the air-water interface more difficult than the theory predicts. When calcium soap was formed in situ by the reaction of fatty acids in the oil with calcium, solid soap particles were observed at the surfaces of the oil drops. The combination of oil and calcium soap produced a synergistic effect facilitating the well-known bridging instability of foam films or Plateau borders and producing a substantial defoaming effect. A possible mechanism of instability involving increases in disjoining pressure at locations where small soap particles approach the air-water interface is discussed. For both surfactants with the triolein-oleic acid mixtures, calculated entry and bridging coefficients for conditions when calcium soap formed were positive shortly after foam generation but negative at equilibrium. These results are consistent with the experimental observation that most defoaming action occurred shortly after foam generation rather than at later times. (C) 2003 Elsevier Inc. All rights reserved.