An air-breathing direct methanol fuel cell (DMFC) is attractive for portable-power applications. There are, however, several barriers that must be overcome before DMFCs reach commercially viability. This study shows that the cell power density is strongly affected by the fabrication conditions of the membrane electrode assembly (MEA) and by the technique used for assembly of the cell components. The results indicate that reducing the pressure and the thickness of catalyst layer in the MEA fabrication process can significantly improve power density. The production of water at the cathode, especially at a high power density, is shown to have a strong impact on the operation of an air-breathing DMFC since water blocks the feeding of air to the cathode. The power density (greater than or equal to20 mW cm(-2)) of an air-breathing DMFC is found to drop to nearly half of its initial value after 30-40 min of operation in a short-term stability test. This appears to be one of the major limitations for potable electronic applications. Despite the many practical difficulties associated with an air-breathing DMFC, an attempt is also made to highlight the importance of the component assembly technique using a small cell pack with four integrated unit cells. (C) 2003 Elsevier Science B.V. All rights reserved.