The effect of degree of polymerization (DP) on the gelation and flow processability of poly(vinyl chloride) (PVC) was studied. Sheets with adjusted degree of gelation were prepared by rolling rigid pipe formulation suspension PVC compounds with DPs of 800,1050 and 1300 by changing the milling temperature. Their degrees of gelation were measured with DSC and their capillary flow properties were measured with a capillary rheometer at 150, 170 and 190degreesC and the effect of DP on the relation between gelation and flow processabilities was studied. Because of the higher shearing heat during milling, the sample with the higher DP had a higher history temperature and thus tended to show a higher degree of gelation. The viscosity increased as the gelation increased. The dependency of viscosity on DP was higher at higher milling and extrusion temperatures and thus at a higher degree of gelation and a lower shear rate. This was assumed to be attributed to the more prominent uniform molecular flow as against the particle flow. The die swell increased with increasing the milling and extrusion temperatures and hence with increasing the gelation. A sample with a lower DP tended to show a larger die swell and this tendency was even more pronounced at the higher extrusion temperature. The melt fracture easily occurred when a sample with advanced gelation was extruded at low temperature. Whereas at low milling temperatures a sample with the lower DP showed a lower critical shear rate at onset of melt fracture, and thus easily generating melt fracture, at high milling temperatures it showed a higher critical shear rate and hence scarcely generated melt fracture. These experimental results were explained by the fact and concept that a sample with a lower DP shows a higher increase in the gelation during extrusion and/or the slighter feature of particle flow as against the uniform molecular flow at the same gelation level. (C) 2004 Wiley Periodicals, Inc.