Journal of Colloid and Interface Science, Vol.271, No.1, 212-219, 2004
Asphaltene aggregation in organic solvents
Asphaltenic solids formed in the Rangely field in the course of a carbon dioxide flood and heptane insolubles in the oil from the same field were used in this study. Four different solvents were used to dissolve the asphaltenes. Near-infrared (NIR) spectroscopy was used to determine the onset of asphaltene precipitation by heptane titration. When the onset values were plotted versus asphaltene concentrations, distinct break points (called critical aggregation concentrations (CAC) in this paper) were observed. CACs for the field asphaltenes dissolved in toluene, trichloroethylene, tetrahydrofuran, and pyridine occurred at concentrations of 3.0, 3.7, 5.0, and 8.2 g/l, respectively. CACs are observed at similar concentrations as critical micelle concentrations (CMC) for the asphaltenes in the solvents employed and can be interpreted to be the points at which rates of asphaltene aggregations change. CMC values of asphaltenes determined from surface tension measurements (in pyridine and TCE) were slightly higher than the CAC values measured by NIR onset measurements. The CAC for heptane-insoluble asphaltenes in toluene was 3.1 g/l. Thermal gravimetric analysis (TGA) and elemental compositions of the two asphaltenes showed that the H/C ratio of the heptane-insoluble asphaltenes was higher and molecular weight (measured by vapor pressure osmometry) was lower. (C) 2003 Elsevier Inc. All rights reserved.