화학공학소재연구정보센터
Powder Technology, Vol.142, No.1, 59-69, 2004
Nanocoating individual cohesive boron nitride particles in a fluidized bed by ALD
Experiments are conducted with alumina (Al2O3) deposition on a wide size range of hexagonal boron nitride (BN) platelet-like particles. Successful deposition of alumina films on these particles, with film thickness controllable at the Angstrom level, is observed based upon TEM imaging, ICP-AES, particle size distributions, and surface area analysis. While fluidizing, fine BN particles aggregate in the bed. The aggregates are the entities fluidizing, not the primary particles. However, individual particles are coated using Atomic Layer Deposition (ALD), not aggregates. Since ALD is a surface chemistry phenomenon, the films grow uniformly on every primary particle. BN particles are small platelets with different functional groups on the basal planes and edge planes. A small exposure to reagents [2.5 x 10(6) Langmuir (L) per reagent per cycle], will only coat the edge planes of uncoated BN particles. A larger dose of 1 x 10(8) L will coat the entire uncoated BN particle (edge and basal planes). After 10 ALD cycles of the 1 x 10(8) L dose, the exposures can be reduced to 1 x 10(6) L as the film is then growing on alumina and not BN. Peel strength data indicate that adhesion between the coated particles and a cured epoxy in a filled composite is similar to 25% stronger than that of uncoated particles and the epoxy. The overall thermal conductivity drops similar to 17% for an identical filler loading as expected due to the additional thermal resistance added by the film. However, the viscosity of an epoxy resin loaded with coated BN is as much as five times lower than that of the resin loaded with the same amount of uncoated BN. These results indicate that the loading of Al2O3 nanocoated BN particles in an epoxy matrix can be substantially increased relative to that of uncoated particles. The thermal conductivity of the more highly filled composite will be increased without adversely impacting filled resin viscosity or the peel strength of the cured material. This is the first reported study indicating that cohesive primary particles that fluidize as aggregates in a fluidized bed can be individually coated with a nano-thick ceramic film using ALD. (C) 2004 Elsevier B.V. All rights reserved.