Natural polyelectrolytes are suitable coagulants for the treatment of industrial and minicipal wastewaters because they are safe and have environmental benefits. Chitosan, a natural cationic polyelectrolyte, and other similar coagulants were used in the treatment of an olive oil water suspension as a model for the processing wastewater. The effect of chitosan, starch, alum and ferric chloride on the coagulation of oil droplets were determined by the jar test apparatus and turbidometric measurements. Olive oil emulsion samples were prepared by the use of surface active agents and other agents that could form stable oil water emulsions. The effect of parameters such as pH, ionic strength and optimum dosage of the coagulants were determined in the jar test experiments. Following the jar experiments, with the optimum concentration of the suitable coagulant, the emulsions were placed in an induced air flotation (IAF) cell to separate the coagulated oil droplets from solution. In the air flotation experiments, the effect of temperature, surfactant concentration and air flowrate were determined on the decrease of turbidity and COD of the emulsion samples. In the jar experiments, chitosan and alum used together at concentrations of 15 and 25 ppm, respectively, at pH 6 produced the lowest turbidity values. In the air flotation experiments, a concentration of 100 ppm of chitosan, an air flowrate of 31/min, aeration time of 45 s, temperature of 20 degreesC and pH 6 produced optimum levels. At optimum conditions of coagulation and flotation stages, the COD of the olive oil emulsion could be reduced by 95%. (C) 2004 Published by Elsevier Ltd.