The pendant and sessile drop profile analysis using the finite element method (PSDA-FEM) is an algorithm which allows simultaneous determination of the interfacial tension (gamma) and contact angle (theta(C)) from sessile drop profiles. The PSDA-FEM algorithm solves the nonlinear second-order spherical coordinate form of the Young-Laplace equation. Thus, the boundary conditions at the drop apex and contact position of the drop with the substrate are required to solve for the drop profile coordinates. The boundary condition at the position where the drop contacts the Substrate may be specified as a fixed contact line or fixed contact angle. This paper will focus on the fixed contact angle boundary condition for sessile drops on a substrate and how this boundary condition is used in the PSDA-FEM curve-fitting algorithm. The PSDA-FEM algorithm has been tested using simulated drop shapes with and without the addition of random error to the drop profile coordinates. The random error is varied to simulate the effect of camera resolution on the estimates of gamma and theta(C) values obtained from the curve-fitting algorithm. The error in the experimental values for gamma from sessile drops of water on acrylic and Mazola corn oil on acrylic falls within the predicted range of errors obtained for gamma values from simulated sessile drop profiles with randomized errors that are comparable in magnitude to the resolution of the experimental setup. (c) 2005 Elsevier Inc. All rights reserved.