Several samples of chitosan with different degrees of deacetylation and of different molecular weights were tested for the coagulation-flocculation of organic suspensions. Organic suspensions were prepared by mixing mushroom powder with tap water. Experiments were carried out at pH 5, pH 7, and pH 9. Because decreasing the pH reduced the amount of chitosan required to reach the required turbidity, at pH 9, a high concentration of chitosan was required to achieve the required treatment levels, whereas the difference was less significant between pH 7 and pH 5 (the required concentration of chitosan was halved). Though viscosity, correlated to the molecular weight of chitosan, affected treatment performance, its influence on the efficiency of coagulation-flocculation could be substantially reduced by slightly increasing the concentration of the polymer. This is of importance in the processing of industrial effluents: the aging of a chitosan solution, which may cause partial depolymerization, and loss of viscosity, will have a limited impact on process efficiency. The degree of deacetylation also has a limited effect on treatment performance, especially when the degree of deacetylation exceeds 90%. (c) 2005 Wiley Periodicals, Inc.