Static tests and ultrasonic measurements (2.25 MHz) have been carried out on a series of composite laminates of glass fibres in a polypropylene matrix. A range of angle ply laminates were prepared for this study, with laminate angles theta of +/- 0, 10, 20, 30 and 40 degrees. The high frequency measurements were made using the ultrasonic immersion technique, which allows the determination of a complete set of the elastic constants of a material. The relationship between the ultrasonically determined elastic constants of the angle ply laminates was found to be in excellent agreement with theoretical predictions, as previously validated for carbon fibre/epoxy angle ply laminates. A comparison between the ultrasonic and statically measured values was made for two of the angle ply laminates (theta = 0 and 20 degrees). It was found that the static values were lower than those measured at ultrasonic frequency, particularly those constants that were more matrix dominated (for example the transverse moduli of the laminates). Measurements on a pure polypropylene sample at both testing frequencies confirmed that the change in matrix properties with frequency was the cause of this difference. The change in properties with test frequency is likely to be much larger in this system than in other composite materials because the glass transition temperature of polypropylene is close to ambient temperature. Dynamic mechanical tests (1 Hz) were carried out on a sample of pure polypropylene to assess this effect. We also give an appropriate method of estimating the dependence of glass transition temperature on frequency. The results for polypropylene are compared with those for other commonly used polymer matrix materials: epoxy resin, nylon and polyetheretherketone (PEEK): DMTA measurements were also made on these samples. The effect of test frequency on matrix properties, for the glass/PP laminates, was further investigated by examining the relationship of the Poisson's ratios with laminate angle using a mixture of ultrasonic experiments and theoretical predictions. Previously we have shown that the degree of anisotropy between the reinforcing fibre and the matrix phase is paramount in determining whether the material will show a negative Poisson's ratio at a critical laminate angle. The ultrasonic measurements carried out in this study on the glass/PP laminates showed a minimum in one of the Poisson's ratio at a laminate angle of 32 degrees, but the value did not become negative. However, theoretical predictions showed that for a static frequency measurement (1 Hz), where the matrix is softer and hence the anisotropy of each laminate ply is higher, the laminate will show a negative Poisson's ratio with a minimum at a laminate angle of around 28 degrees. (c) 2005 Springer Science + Business Media, Inc.