Several low cost biomaterials such as baggase, charred rice husk, activated charcoal and eucalyptus bark (EB) were tested for removal of chromium. All the experiments were carried out in batch process with laboratory prepared samples and wastewater obtained from metal finishing section of auto ancillary unit. The adsorbent, which had highest chromium(VI) removal was EB. Influences of chromium concentration, pH, contact time on removal of chromium from effluent was investigated. The adsorption data were fitted well by Freundlich isotherm. The kinetic data were analyzed by using a first order Lagergren kinetic. The Gibbs free energy was obtained for each system and was found to be -1.879 kJmol(-1) for Cr(VI) and -3.885 kJmol(-1) for Cr(III) for removal from industrial effluent. The negative value of Delta G(0) indicates the feasibility and spontaneous nature of adsorption. The maximum removal of Cr(VI) was observed at pH 2. Adsorption capacity was found to be 45 mg/g of adsorbent, at Cr(VI) concentration in the effluent being 250 mg/l. A waste water sample containing Cr(VI), Cr(III), Mg, and Ca obtained from industrial unit showed satisfactory removal of chromium. The results indicate that eucalyptus bark can be used for the removal of chromium. (c) 2005 Elsevier Ltd. All rights reserved.